Size Color Type - Template
Template
Product Compliance Statement
The product described below is manufactured in an ISO 9001:2015, ISO 14001:2015, and GFSI certified facility using good manufacturing practices (GMP). Food & Drug Administration (FDA) Compliance information available upon request.
Top Layer -
Middle Layer -
Bottom Layer -
Description | Information |
---|---|
Product Code | S1LP2CPETSW301 |
Structure | 48 ga PET/Adhesive/1.5 mil LLDPE |
Manufacturing Location | USA |
Property | Expected Value | Unit of Measure | Reference Method |
---|---|---|---|
Total Yield | 12706 | sq in/lb | Calculated |
Total Thickness | 2 | Mil | Ream Weight |
Gauge | .50 | microns | Electronic Caliper |
Seal Strength | '>1000 | grams/in2 | 300F°, 40 PSI, 0.50 sec |
SIT | 250* | °F | 40 PSI, 0.75 sec |
COF | 0.13 | Static – sealant side | ASTM d 1894 |
MVTR | 0.60 | g/100in2/day | Mocon Unit |
OTR | 7 | cc/100in2/day | Mocon Unit |
Surface Dyne Level | 52** | Dyne/cm | ASTM D2578 |
Shelf Life | 1 year | 50 – 80 °F, 30 – 70% RH | - |
*Using one-side heat sealer. May not be representative of filling equipment.
**Target value based on incoming raw material. Bump treating or priming is always recommended prior to printing or applying adhesive to the printable surface.
Product Performance & Suitability: All the descriptive information and recommendations should be used only as a guide. Furnishing information and recommendations shall in no event constitute a warranty of any kind. All purchasers shall independently determine the suitability of the material for the purpose for which it is purchased. Seller’s and manufacturer’s only obligation shall be to replace such quantity of the product proved to be defective. Neither the seller nor manufacturer shall be liable either in tort or in contract for any loss or damage, direct, incidental or consequential (Including loss of profits or revenue) arising out of the use of or the inability to use the product. No statement or recommendation not contained herein shall have any force or effect unless in agreement signed by officers of seller and manufacturer.
Updated less than a minute ago